Loading
Data Processing Engine
Run a Data Processing Engine Definition from the Builder

You are here:

  1. Salesforce Help
  2. Docs
  3. Data Processing Engine

Run a Data Processing Engine Definition from the Builder

Run or test an active Data Processing Engine definition at any time from the builder. When running a definition from the builder, you can provide input variable values that are used only for that run. You can run the definition in a debug mode to save additional information about the definition’s run.

Required Editions

View supported editions.
User Permissions Needed
To open and run a Data Processing Engine definition: View permissions information.

You can’t start two runs of a definition with the same input variable values simultaneously. If your definition doesn’t contain input variables, you can't start two simultaneous runs.

Warning
Warning When you start multiple simultaneous runs, make sure that the runs don't process the same data multiple times and write back duplicate results, or overwrite another run's results.

After a definition is run from the builder, you can track its progress and debug results.

Run Definitions from Builder with CRM Analytics Runtime

  1. From Setup, in the Quick Find box, enter Data Processing Engine, and then select Data Processing Engine.
  2. Open an active definition that you want to run.
  3. Click Run Definition, then click Next.
  4. Select the debug modes that you want to use for the run:
    • Save Recipe and its Output Records
    • Save Count of Node Records
    • Save Node Output Without Writing Back Results.
  5. If you select only the Recipe and its Output Records as the debug mode:
    1. Click Next.
    2. Enter the input variable values that you want to use for the run.
    3. Click Run Definition.
  6. If you select Save Count of Node Records as one of the debug modes:
    1. Click Next.
    2. Enter input variable values that you want to use for the run and click Next.
    3. Select up to 20 transformation nodes for which you want to get an output record count.
    4. Click Run Definition.
  7. If you select Save Node Output Without Writing Back Results as one of the debug modes:
    1. Click Next.
    2. Enter input variable values that you want to use for the run and click Next.
    3. Select Data Source nodes for which you want to use a specific set of source records and enter the IDs of up to 5 records for each selected node.
    4. Click Next.
    5. Select up to 20 transformation nodes for which you want to get an output record count.
    6. Click Run Definition.

Run Definitions from Builder with Data 360 Runtime

  1. From Setup, in the Quick Find box, enter Data Processing Engine, and then select Data Processing Engine.
  2. Open an active definition that you want to run.
  3. Click Run Definition, then click Next.
  4. To run the definition with the Save Count of Node Records debug mode:
    1. Select Show output record count for nodes.
    2. Select the transformation nodes for which you want output record count.
  5. Click Run Definition.
 
Загрузка
Salesforce Help | Article